Процедура след смяна на антифриз

[INTEGRALE Профил Уеб-сайт]

1.
Connect battery charger.
2.
Switch on ignition.
3.
...Set heater to maximum temperature, activate "Automatic" button, then reduce fan to lowest setting.
4.
Press accelerator pedal for 10 seconds to floor. Engine must not be started.
5.
The venting procedure is started when the accelerator pedal is pressed and takes approx. 12 minutes.
6.
Then top up fill level in coolant expansion tank with 250 ml above max (see illustration).
7.
Check cooling system for leaks .
8.
If the venting procedure has to be carried out several times, allow DME to drop completely (ignition key removed for approx. 3 minutes), then repeat from Point 3.

[joropc Профил]

9... на другата сутрин, провери нивото на антифриза на СТУДЕН мотор и ако трябва - долей.